FUTABA 10CAP Instruction Manual page 19

• When you install the switch harness to the helicopter, please use the switch cover. Generally sandwich the frame by
switch and switch cover and securely tighten the screws. Different models might require different installations. In that
case, please follow the model instruction manual.
provide a margin so that the wire sticks out slightly and fasten it at suitable
points. In addition, periodically check the wire during daily maintenance.
IMPORTANT: Since the 2.4GHz have different characteristics than that of the conventional 27MHz and 72MHz
• The R6014FS has two antennas. These antennas have a diversity
function to decrease the chance of a receiving error.
• Since the wavelength of the 2.4GHz is much shorter than that
of the conventional frequencies 27MHz and 72MHz, it is very
susceptible to loss of signal which results in a receiving error.
In order to avoid this phenomenon, the R6014FS adopted a
diversity antenna system.
• To obtain the best results of the diversity function, please refer to the following instructions;
1. The two antennas must be kept as straight as possible. Otherwise it will reduce
the effective range.
2. The two antennas should be placed at 90 degrees to each other.
away from each other as much as possible.
Larger models can have large metal objects that can attenuate the RF signal.In
this case the antennas should be placed at both sides of the model. Then the best
3. The antennas must be kept away from conductive materials, such as metal and
carbon by at least a half inch. The coaxial part of the antennas does not need to follow these guidelines, but do not bend it
in a small radius.
4. Keep the antennas away from the motor, ESC, and other noise sources as much as possible.
*The two antennas should be placed at 90 degrees to each other.
*The main purpose of the photo demonstrates how the antenna should be placed.
protect it from vibration.
Antenna
Antenna
*Must be kept as straight as possible.
Antenna
19
Fasten about 5-10cm
from the servo outlet
so that the lead wire
is neat.
Margin in the lead wire.
Coaxial cable
R6014FS Receiver