Transmitter Displays And Buttons - FUTABA 10CAP Instruction Manual

TRANSMITTER DISPLAYS & BUTTONS
leading to an immediate crash.
16/64/128: CAMPac display (10C data)
9C: CAMPac display (9C/9CS data)
Timers
Throttle/Elevator trim Model number
display
Rudder trim
MODE END
key key
MODE BUTTON: (key)
Press and hold MODE BUTTON for one second to open programming menus. Press
between BASIC and ADVANCE menus. HELI only: Press MODE BUTTON to scroll between conditions in certain
functions.
END BUTTON: (key)
Press END BUTTON to return to previous screen. Closes functions back to menus, closes menus to start-up screen.
CURSOR LEVER:
Control CURSOR LEVER
function.
Press CURSOR LEVER
Turn DIAL:
Turn DIAL clockwise or counterclockwise to scroll through choices within an option of a function (for example, to
Press DIAL:
Press DIAL to select the actual function you wish to edit from the menu.
Press DIAL
memory, copy one model memory over another, trim reset, store channel position in FailSafe, change model type,
reset entire model. System will ask if you are sure.
Press DIAL again to accept change.
MIX: Mixer Alert
and name
Aileron trim
display display
N
Modulation indicator
(PCM1024/PPM FM)
(2.4G-7CH/10CH)
Elevator/Throttle trim
display
CURSOR lever
Total timer display <TIMER>
Shows the cumulated ON time. (hours:minutes)
Up/down timer display <ST1.ST2>
(minutes:seconds)
Model timer display <MDL>
PUSH
Shows the cumulated ON time for each model.(hours:minutes)
Resetting timers:
Select the desired timer with CURSOR lever. The timer
display flashes. To reset the timer, press Dial for one second.
Battery Dial
voltage
BASIC or ADVANCE menu or a function.
23
MODE BUTTON to switch
N
N