Timer Submenu - FUTABA 10CAP Instruction Manual

TIMER submenu (stopwatch functions): controls three electronic clocks used to keep track of time remaining in a
Adjustability:
• Count down timer: starts from the chosen time, displays time remaining. If the time is exceeded, it continues to count
below 0.
• Count up timer: starts at 0 and displays the elapsed time up to 99 minutes 59 seconds.
• Count down timer (Stop type): starts from the chosen time, displays time remaining, and stops at 0.
• Model timer: cumulates ON time up to 99 hours 59 minites each model. Once Model timer function is turned off, the
cumulate time will also be reset to "0:00".
• Independent to each model, and automatically updates with model change.
• In either TIMER mode, the timer beeps once each minute. During the last twenty seconds, there's a beep each two seconds.
DOWN TIMER )
• To Reset, choose the desired timer with the CURSOR lever (while at the startup screen), then press and hold DIAL for 1
second.
• Activation by either direction of SWITCH A-H, by THROTTLE STICK ( STK-THR ) (Using the THROTTLE STICK is
convenient if you are keeping track of fuel remaining, or for an electric, how much battery is left), by LOGIC SWITCH
Lsw1-Lsw3 or by the power SWITCH ( PWR SW ). Set up LOGIC SW : See p. 38.
• Also the reset switch can be assigned (SWITCH A-H or LOGIC SWITCH Lsw1-Lsw3)
GOAL of EXAMPLE:
b e i n g c o n t r o l l e d b y T H R O T T L E
STICK position. This is utilized to keep
track of actual Throttle on time to better
Where next?
TIMER<1>
TIMER<2>
TIMER<3>
STEPS:
Open BASIC menu, then open TIMER
function.
Go to TIMER<2> .
Adjust time to 4 min. 30 sec., count
down.
Assign to THROTTLE STICK and set
trigger point.
Close.
Adjust END POINTs
Set up TRAINER functions: see p. 47.
45
(Home screen)
INPUTS:
for 1 second.
(If ADVANCE ,
to page 2.
to TIMER .
C
C to 10 (TIMER<2>).
to 4 . C to 00 (TIMER<2>).
to 30.
C to ON>SwA (TIMER<2>).
to STK THR .
to 50% . for 1 second to NULL .
C
THROTTLE STICK to desired
for 1 second to set.
again.)