Logic Sw; Servo Reverse - FUTABA 10CAP Instruction Manual

Logic switch selection ( LOGIC SW ): The various functions in the T10C can be selected by switch. The Logic switch can be
assigned to the following functions: THR-CUT , IDLE DOWN , AUX-CH , TIMER , PROG. MIX , AIRBRAKE , ELEV-FLAP , and AILE-FLAP
functions. The logic switch can activate functions by two switches combination. The 2 types of logic, either AND or OR,
can be selected.
GOAL of EXAMPLE:
Ex: Switch A and B are calculated by
AND logic. (A = down, B = down)
Servo reversing ( REVERSE ): changes the direction an individual servo responds to a CONTROL STICK motion.
[Since channel 9 and 10 are switch only (and only available with a PCM or 2.4G-10CH mode), its servo REVERSE is in the
AUX-CH control screen with its switch assignment. See p. 46.]
For CCPM helicopters, be sure to read the section on SWASH AFR (p. 95) before reversing any servos.
NOTE: THR-REV is a special function that reverses the entire throttle control, including moving the trim functionality to
the Stick's upper half. To use THR-REV , turn off the transmitter, hold down the MODE and END keys, turn on. CURSOR
DOWN to THR-REV and turn the DIAL to REV . Turn the transmitter off and back on. This change affects all models in the
radio.
GOAL of EXAMPLE:
Reverse the direction of the elevator
servo.
Where next?
Adjustability:
• Three logic switches can be used.
(Lsw1, Lsw2, and Lsw3)
• SW(1): Any SWICH A-H or THR-
STKS, SW(2): Any SWICH A-H
• Switch position ( POSI )
• Logic mode: AND or OR ( MODE )
STEPS:
Open BASIC menu, then open LOGIC
SW menu.
Go to POSI and change setting.
(Ex: DOWN )
Next, SW = B , POSI = DOWN
Close.
Except with CCPM helicopters, always complete your servo reversing prior to
any other programming. If you use pre-built ACRO GLID functions that control
multiple servos, such as FLAPERON or V-TAIL , it may be confusing to tell whether
the servo needs to be reversed or a setting in the function needs to be reversed.
See the instructions for each specialized function for further details.
Always check servo direction prior to every flight as an additional
STEPS:
Open REVERSE function.
C h o o s e p r o p e r c h a n n e l a n d s e t
direction. (Ex: ELE REV )
Close.
Adjust servo travel with END POINT : see p. 39.
Set up trainer functions: see p. 47.
38
Logic combination table:
SWITCH
SW(1) SW(2)
off off
off on
on off
on on
INPUTS:
for 1 second.
(If ADVANCE ,
to 2nd page of menu.
C to LOGIC SW .
C to POSI .
to DOWN .
Repeat.
INPUTS:
for 1 second.
(If ADVANCE ,
to REVERSE .
C
C to ELE .
to REV . for 1 second.
D/R , EXP ): see p. 42.
LOGIC
AND OR
off off
off on
off on
on on
again.)
again.)