Hovering Setups - FUTABA 10CAP Instruction Manual

HOVERING ADJUSTMENTS ( HOV-THR and HOV-PIT ):
curves for ideal setup.
Adjustability:
• Both adjustments may be inhibited if not desired.
• Both adjustments may also be set to NULL , temporarily turning off the knob but maintaining the last memorized setting.
• Adjustments may be memorized and then the knobs returned to center point to use that amount of adjustment. Allows
easy use of the trimming knobs for multiple models. (Note that when memorization is repeated with the knob offset from
center, the trim value accumulates.)
• Adjustments are quickly reset to the initial value by turning the dial until the trim reads 0%, memorizing, then returning
the knob to its center position.
• Note that all functions, including these, assume the model hovers at half stick.
• Available in normal ( NORM
GOAL of EXAMPLE:
Fine-tune hovering with the hovering
adjustments. Remember these affect
only the hovering (normal) condition.
Adjust throttle and collective pitch
curves until model hovers nicely. In
curves near hover point independently
with HOV-THR and HOV-PIT knobs.
Where next?
NORM/IDL1 ) condition only.
STEPS:
Open the HOV-THR function.
Optional: change which knob adjust
seach hovering curve. NULL locks in
curve in last stored position.
Store the current dial settings prior to
selecting another model.
Close.
Open the HOV-PIT function.
Store the current dial settings prior to
selecting another model.
Close.
THR-HOLD : see p. 99.
Setting up the Idle-Ups: Throttle and Collective pitch Curves and Revo. Mixing
( TH-CURVE, PIT-CURVE, REVO. MIX ) for idle-ups: see p. 101.
D/R , EXP : see p. 42.
104
INPUTS:
for 1 second.
(If BASIC ,
C to HOV-THR .
C to VR .
to desired knob and direction.
C to RATE .
for one second to store.
or VR(C) to center.
C to HOV-PIT .
to RATE .
C
for one second to store.
or VR(A) to center.
again.)