Parameters; Pcm/Ppm, D/R Sw Dir, 9Ch Sw Position) - FUTABA 9VAP Instruction Manual

PARAMETER
Servo Test: Each servo is operated in linear fash-
ion from neutral, to its maximum and minimum
positions. The operation is repeated sequentially
for Channels 1 through 8.
Mixing Mode: In the BASIC mode, all mixing
circuits except Programmable Mixing are de-
activated. In the AERO mode, all circuits are
useable.
PCM/PPM: PCM or PPM encoding can be select-
ed with this function. PPM encoding allows the
transmitter to be used with standard FM re-
ceivers.
to Line 2 with the
play the PARAMETER screen by pressing the
program key.
2) Servo Test: Move the cursor to the SERVO-
TEST position with the
key. Turn the function ON and OFF with the
and program keys.
3) MIX-MODE: Move the cursor to the MIX-
MODE position with the
key. Select either the BASIC or AERO mixing
mode by pressing the
key.
4) PCM/PPM: Move the cursor to the PCM/PPM
position with the
select the desired encoding method by pres-
sing the
cursor key, then dis-
cursor or
cursor or
program or
cursor key and or
program key. or
D / R SW D / R : The ON/OFF directions of the
D/R Switches can be selected. In Mode 1, the
upper position is the D/R ON (low rate) position,
and in Mode 2, the lower position is the ON
position.
9CH SW POS: The position of the CH9 switch
can be selected. In SW POS 1, the CH9 Switch
becomes the RUD D/R switch position. For SW
POS 2, the CH9 Switch position is at the CH5
switch and CH5 is controlled by the CH7 Knob.
(Therefore, when AIL DIFF mixing is used, all 9
channels can be used effectively.)
NOTE: Encoding will not change until the
transmitter is turned OFF and back
ON again.
5) Dual Rate Switch Direction: Move the cursor
to the D/R SW DIR position and select Mode
key.
6) Channel 9 Switch Position: Move the cursor
to the 9CH SW POS position and select SW
POS 1 or 2 with the
key.
7) Return to the EDIT screen by pressing the
program key.
or program
program or