Cisco 7940 - IP Phone VoIP Administration Manual page 62

Network Configuration Menu
Table 4-2 Network Configuration Menu Options (continued)
Option Description
SW Port Speed and duplex of the switch port.
Configuration
If the phone is connected to a switch, you must configure
port on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change the
PC Port Configuration option to the same setting.
PC Port Speed and duplex of the PC port. Valid values:
Configuration
If the phone is connected to a switch, you must configure
port on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change the
SW Port Configuration option to the same setting.
TFTP Server 2 Optional backup TFTP server that the phone uses if the
primary TFTP server is unavailable.
User Locale User locale associated with the phone user. The user locale
identifies a set of detailed information to support users,
including language, font, date and time formatting, and
alphanumeric keyboard text information.
Network Locale Network locale associated with the phone user. The network
locale identifies a set of detailed information that supports
the phone in a specific location, including definitions of the
tones and cadences used by the phone.
User Locale Version of the user locale loaded on the phone.
Version
Network Locale Version of the network locale loaded on the phone.
Version
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP)
4-8
Chapter 4 Configuring Network Settings on the Cisco Unified IP Phone
To Change
Scroll to the SW Port Configuration
1.
option and then press the Edit softkey.
Enter one of these values:
2.
A (Auto Negotiate)
–
10H (10-BaseT / half duplex)
–
10F (10-BaseT / full duplex)
–
100H (100-BaseT / half duplex)
–
100F (100-BaseT / full duplex)
–
Press press the Save softkey.
3.
1. Scroll to the PC Port Configuration
option and then press the Edit softkey.
Enter one of these values:
2.
A (Auto Negotiate)
–
– 10H (10-BaseT / half duplex)
– 10F (10-BaseT / full duplex)
– 100H (100-BaseT / half duplex)
100F (100-BaseT / full duplex)
–
Press press the Save softkey.
3.
Set the Alternate TFTP option to Yes.
1.
Scroll to the TFTP Server 2 option,
2.
press the Edit softkey, and then enter a
new backup TFTP server IP address.
Press the Validate softkey, and then
3.
press the Save softkey.
From Cisco Unified Communications
Manager, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications
Manager, choose Device > Phone > Phone
Configuration.
Display only—cannot configure.
Display only—cannot configure.
OL-15498-01