Editing Values - Cisco 7940 - IP Phone VoIP Administration Manual

Network Configuration Menu
Table 4-1 Settings Configurable from the Network Configuration Menu
Category Description
IP settings If you do not use DHCP in your network, you can make IP settings
manually.
Port settings Allow you to set the speed and duplex of the network and access ports. SW Port Configuration
TFTP settings If you do not use DHCP to direct the phone to a TFTP server, you must
manually assign a TFTP server. You can also assign an alternative
TFTP server to use instead of the one assigned by DHCP.
VLAN settings Admin. VLAN ID allows you to change the administrative VLAN used
by the phone. PC VLAN allows the phone to interoperate with
third-party switches that do not support a voice VLAN.
Related Topics
•
•
•
•
Network Configuration Menu
The Network Configuration menu contains options for viewing and making a variety of network settings.
Table 4-2
For information about how to access the Network Configuration menu, see the
Configuration Menu" section on page
Before you can change an option on this menu, you must unlock options as described in the
and Locking Options" section on page
configuration options appear on the Cisco Unified IP Phones 7960G/7940G only if options are unlocked.
For information about the keys you can use to edit options, see the
Table 4-2 Network Configuration Menu Options
Option Description
DHCP Server IP address of the Dynamic Host Configuration Protocol
(DHCP) server from which the phone obtains its IP address.
BOOTP Server Indicates whether the phone obtains its configuration from
a Bootstrap Protocol (BootP) server instead of from a
DHCP server.
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP)
4-4
Displaying the Network Configuration Menu, page 4-1
Unlocking and Locking Options, page 4-2
Editing Values, page 4-3
Network Configuration Menu, page 4-4
describes these options and, where applicable, explains how to change them.
Chapter 4 Configuring Network Settings on the Cisco Unified IP Phone
4-1.
4-2. The Edit, Yes, or No softkeys for changing network
To Change
Display only—cannot configure.
Display only—cannot configure.
Network Configuration
Menu Option
IP Address
Default Router 1-5
Subnet Mask
Domain Name
DNS Server 1-5
PC Port Configuration
TFTP Server 1
Alternate TFTP Server
TFTP Server 2
Admin. VLAN ID
PC VLAN
"Displaying the Network
"Unlocking
"Editing Values" section on page
OL-15498-01
4-3.