Adding Phones With Auto-Registration And Taps; Adding Phones With Cisco Unified Communications Manager Administration - Cisco 7940 - IP Phone VoIP Administration Manual

Unified ip phone cisco unified communications manager 7.0 (sccp)
Hide thumbs Also See for 7940 - IP Phone VoIP:
Table of Contents

Advertisement

Adding Phones to the Cisco Unified Communications Manager Database
Table 2-4
Methods for Adding Phones to the Cisco Unified Communications Manager Database
Method
Auto-registration
Auto-registration with
TAPS
Using the Cisco Unified
Communications Manager
Administration
Using BAT
Adding Phones with Auto-Registration
By enabling auto-registration before you begin installing phones, you can:
You should use auto-registration to add less than 100 phones to your network. To add more than 100
Note
phones to your network, use the Bulk Administration Tool (BAT). See the
section on page
In some cases, you might not want to use auto-registration: for example, if you want to assign a specific
directory number to the phone or if you plan to implement authentication or encryption, as described in
Cisco Unified Communications Manager Security Guide. For information about enabling
auto-registration, refer to "Enabling Auto-Registration" in Cisco Unified Communications Manager
Administration Guide.
Cisco Unified Communications Manager automatically disables auto-registration if you configure the
Note
cluster-wide security mode for authentication and encryption through the Cisco CTL client.
Related Topics
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP)
2-8
Requires MAC
Address?
Notes
No
Results in automatic assignment of directory numbers
No
Requires auto-registration and the Bulk Administration Tool (BAT);
updates information in the Cisco Unified IP Phone and in Cisco
Unified Communications Manager Administration
Yes
Requires phones to be added individually
Yes
Allows for simultaneous registration of multiple phones
Automatically add a Cisco Unified IP Phone to the Cisco Unified Communications Manager
database when you physically connect the phone to your IP telephony network. During
auto-registration, Cisco Unified Communications Manager assigns the next available sequential
directory number to the phone.
Add phones without first gathering MAC addresses from the phones.
Quickly enter phones into the Cisco Unified Communications Manager database and modify any
settings, such as the directory numbers, from Cisco Unified Communications Manager.
Move auto-registered phones to new locations and assign them to different device pools without
affecting their directory numbers.
2-10.
Adding Phones with Auto-Registration and TAPS, page 2-9
Adding Phones with Cisco Unified Communications Manager Administration, page 2-9
Adding Phones with BAT, page 2-10
Chapter 2
Preparing to Install the Cisco Unified IP Phone on Your Network
"Adding Phones with BAT"
OL-15498-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents