Cisco 7936 - IP Conference Station VoIP Phone Administration Manual page 68

Verifying System Settings
Table 3-2 System Verification Steps on the Cisco Unified Conference Station (continued)
System Setting
CallManager 1 (CM1)
Address,
CallManager 2 (CM2)
Address,
CallManager 3 (CM3)
Address,
CallManager 4 (CM4)
Address,
CallManager5 (CM5)
Address
TFTP Server 1, TFTP
Server 2, TFTP
Server 3
DSP Version
Alt TFTP
Boot Load ID
App Load ID
HW (hardware)
Revision
Cisco Unified IP Conference Station 7936 Administration Guide
3-6
Description
Identifies the
Cisco Unified CallManager
systems that are available for
processing calls from this
Cisco Unified IP Conference
Station.
One of the
Cisco Unified CallManager
addresses will be displayed on the
screen as active (A) and the other
will be displayed as standby (S).
Indicates the Trivial File Transfer
Protocol (TFTP) Server IP
addresses used by the
IP Conference Station to obtain
configuration files and the
conference station's firmware.
Indicates the DSP version loaded
on the Cisco Unified IP
Conference Station.
Indicates whether or not an
Alternate TFTP Server is enabled
(yes/no).
Indicates the current load ID of the
phone's firmware.
Indicates the current load ID of the
phone's software.
Indicates the hardware revision
level.
Chapter 3 Configuring the Cisco Unified IP Conference Station 7936
Usage Notes
These IP addresses are set automatically
by Cisco Unified CallManager.
The source of the address is indicated by
Addr, TFTP or SRST. "Addr" indicates
the address is from the phone
configuration. "TFTP" indicates a tftp
address. "SRST" indicates an srst server
from the phone configuration.
The IP addresses are set automatically if
DHCP is enabled.
TFTP Server 1 must be manually
configured if Alternate TFTP Usage is
enabled or if DHCP is disabled. TFTP
Server 2 and 3 may be manually
configured if Alternate TFTP Usage is
enabled or if DHCP is disabled.
This number is automatically set by the IP
Cisco Unified IP Conference Station.
This configuration must be manually set.
This is set automatically by the
IP Conference Station.
This is set automatically by the
IP Conference Station.
This number is set automatically by the
IP Conference Station.
OL-10751-01