Chapter 2
Setting Up the Cisco Unified IP Conference Station 7936
Adding Cisco Unified IP Conference Stations Manually
Using DHCP
Step 1
Step 2
Step 3
Step 4
Step 5
OL-10751-01
If you want to assign specific directory numbers to your
Cisco Unified IP Conference Stations without using auto-registration, you must
manually add each station to the Cisco Unified CallManager database.
If you are not using Dynamic Host Configuration Protocol (DHCP) in your
network, you must also manually configure the IP settings and Trivial File
Transfer Protocol (TFTP) server on each station.
Alternatively, you can use DHCP, and manually set the TFTP server. In this case,
wait for the station to start up using DHCP, and then re-assign the TFTP server.
If you are using DHCP in your network without auto-registration, you must
manually add the Cisco Unified IP Conference Station to the
Cisco Unified CallManager database.
To manually add the Cisco Unified IP Conference Station to the network, follow
these steps. For additional information, refer to the Cisco Unified CallManager
documentation or online help.
Procedure
Start Cisco Unified CallManager Administration.
Add a Cisco Unified IP Conference Station to Cisco Unified CallManager by
selecting Device > Add a New Device.
The Add a New Device page displays.
Choose Phone from the Device Type drop-down list box, and click Next.
The Add a New Phone page displays.
Choose the Cisco 7936 phone type and click Next.
The Phone Configuration page displays.
Enter the required fields.
Cisco Unified IP Conference Station 7936 Administration Guide
Preparing to Install
2-5