Configuring Startup Network Settings; Guidelines For Best Performance - Cisco 7936 - IP Conference Station VoIP Phone Administration Manual

Chapter 2 Setting Up the Cisco Unified IP Conference Station 7936

Configuring Startup Network Settings

Guidelines for Best Performance

Note
OL-10751-01
If the Cisco Unified IP Conference Station successfully passes through these
steps, it has started properly.
If you are not using DHCP in your network, you must manually configure the
following network settings on the Cisco Unified IP Conference Station after
installing the station on the network:
IP address
•
• IP subnet mask
Default gateway IP address
•
TFTP server IP address
•
Collect the necessary information and follow the procedures described in
Chapter 3, "Configuring the Cisco Unified IP Conference Station
Follow these guidelines to ensure optimum performance with the
Cisco Unified IP Conference Station 7936 and the external microphones.
See the "Conference Room Setup Examples" section on page 2-22
illustration of proper equipment placement for different conference room
configurations.
Use the Cisco Unified IP Conference Station in closed offices and conference
•
rooms up to 20 feet by 20 feet (without external microphones) and 20 feet by
30 feet (with external microphones).
Place the Cisco Unified IP Conference Station 7936 base on a flat surface
•
and make sure that it is clear from any reflective surfaces.
Maintain a minimum distance of four feet between each external microphone
•
and the Cisco Unified IP Conference Station 7936 base and other objects.
Make sure that all microphones are acoustically unobstructed.
•
Cisco Unified IP Conference Station 7936 Administration Guide
Installing the Cisco Unified IP Conference Station 7936
7936".
for an
2-21