Changing Dhcp Settings; Enabling Dhcp - Cisco 7936 - IP Conference Station VoIP Phone Administration Manual

Chapter 3 Configuring the Cisco Unified IP Conference Station 7936
Note

Changing DHCP Settings

Enabling DHCP

Step 1
Step 2
Step 3
OL-10751-01
You can now access and change certain network parameters, including DHCP,
static IP addressing, IP mask, DNS, Administrative VLAN, and Alternate TFTP.
After all changes are complete, you will be prompted to save the changes. If you
select "YES", the phone will save the changes and reboot. If you select "NO", all
changes will be discarded.
You can also use the Cisco Unified IP Conference Station 7936 web interface to
change network options. See the
Interface" section on page
DHCP automatically assigns IP addresses to devices when you connect them to
the network. Follow the appropriate procedures in this section to enable or disable
DHCP.
DHCP is enabled by default.
To reset DHCP if it becomes disabled, follow these steps:
Procedure
From the Network Setup menu, press the Up or Down scroll button to select
DHCP.
If DHCP is disabled, the option displays as:
DHCP Disabled
Press the Enable softkey to enable DHCP.
Press the Save softkey.
Cisco Unified IP Conference Station 7936 Administration Guide
Accessing Network Configuration Settings
"Cisco Unified IP Conference Station 7936 Web
3-36.
3-9