Configuring The Library; Reconfiguring The Backup Software - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade Kit

To run these tests:
1. From
2. From
3. Select
4. Select the number of times this test will run (if needed).
NOTE Select
test stops.
5. Select

Configuring the Library

Check the mailslot configuration. Since the mailslot will now be the top
right-hand drawer of the upgraded library, remove the tapes from the old
mailslot (0, 1, or 5 slots), and add them to the new mailslot on the top
module. When you power the library on, the library will automatically
reconfigure itself for the upgraded capacity and new mailslot.
The firmware automatically recognizes the upgrade status, so no
additional library configuration is needed.

Reconfiguring the Backup Software

Your software applications may need to be reconfigured or, in some cases,
reinstalled after you have installed additional drives or slots into the
library. In addition, some backup software applications may require the
purchase of additional add-on components and/or licenses when
increasing the number of storage slots or drives. Contact your software
application provider for more information or if newly installed storage
slots and drives are not recognized by your backup software application.
Chapter 3
select
Administration,
options. Select the
Run Test
, use the
Run Test
to select the test.
[OK]
to abort a test. The current test cycle completes before the
[Stop]
to start the test cycle.
[Run]
The test results will display at the conclusion of the test cycle.
Upgrading a 40-Slot Library to 60 Slots
to display additional administrative
[More]
menu.
or key to view available tests.
[-] [+]
Verifying the Connection
3-17