HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade Kit page 35

3. Move the display to the top library module, and connect the cable to
4. Ensure the display cable on both library modules is not obstructing
5. Install the two long T-10 screws that are next to the soft keys to
Figure 2-15 Connecting the Front Panel
6. Re-install the display cover by easing the top of the cover underneath
7. Install the viewing window from the upgrade kit to the bottom library
8. Install the eight screws that connect the chin plates (see Figure 1-4
Chapter 2
the front panel connector. The display attaches to two tabs on the side
of the display opening. Attach the display on the tabs and slide it
down.
the vertical lift transport assembly or any moving parts.
secure the display to the chassis (see Figure 2-15).
the forehead and sliding it down (see Figure 1-4 on page 1-8). Tighten
the two phillips head screws to secure the display cover in place.
module. Tighten the two phillips head screws from the upgrade kit to
secure the window in place.
on page 1-8 for all screw locations). The chin plate that goes between
the library modules is included in the upgrade kit.
Upgrading a 20-Slot Library to 40 or 60 Slots
Moving the Front Panel Components and Display
2-19