HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade Kit page 23

5. If your rack does not have threaded screw holes, select the 4/40 or 6/60
Use the EIA markers as a reference point to ensure the holes on the rack
NOTE
correspond to the holes on the template. The EIA markers on the
templates are represented by #>.
6. Pull the existing library into the rack using the vertical handle on the
7. Remove the top mounting rails (one on each rack column) to allow the
Chapter 2
clip nut template, which matches the height of the upgraded library,
and follow the steps below:
a. Hold the template next to the rack column so that the bottom of
the template aligns with the bottom of the library.
b. Install three clip nuts from the upgrade kit into each front column
of the rack. The top two clip nuts are used for the top mounting
rail. The middle clip nut is used for the trim bracket. For racks
with a 55-mm bezel depth, you can remove the original trim
brackets and push the library flush into the rack to install the
bottom clip nuts.
c. Using the rackmount template, install two clip nuts into each back
column of the rack.
back of the library.
upgrade unit to slide on top of the library.
a. Remove the screws in the front and back that attach the top rails
to the column, and lift each rail up and out of the rack.
b. Save these screws to reinstall the mounting rails.
Upgrading a 20-Slot Library to 40 or 60 Slots
Upgrading 20-Slot Libraries to 40 Slots
2-7