HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade Kit page 15

3. Remove the two screws that connect the display to the chassis
Figure 1-5 Removing the Front Panel Display and RFI Shield
4. Remove the front panel display by sliding it upward, then gently
5. Disconnect the cable from the back of the display by grasping the
CAUTION Ensure the display cable is not obstructing the internal moving parts.
Secure the cable to the side of the chassis.
6. Remove the black RFI display shield, which is located behind the
Chapter 1
(Figure 1-5). Save these screws to later reconnect the display.
lifting it away from the front of the library.
sides of the connector and pulling outward. Place the front panel in
an ESD-protected area.
display (Figure 1-5). Two screws secure the sheet-metal shield to the
library chassis.
Preparing a 2/20 and 4/40 Library for the Upgrade
Removing the Front Panel Display
1-9