HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade Kit page 31

7. For rackmounted libraries with a bezel depth of 55 mm, install the
Figure 2-11 Installing the Trim Brackets
8. Using the vertical handle on the back of the library, pull the library
9. For rackmounted libraries with a bezel depth of 55 mm, tighten the
10. Remove the cards and slot covers from the back of the existing library
11. From the back of the library and using an additional light source,
NOTE Make a note of the card locations and cable configuration.
Chapter 2
trim brackets on the side of the library (Figure 2-11).
into the rack.
trim bracket screws to secure the library to the rack.
to access the interconnect cable. Place the cards in an ESD-protected
area.
connect the interconnect cable from the motherboard on the upgrade
module to the motherboard on the existing library. The connection
should go from the top connector of the existing library to the bottom
connector of the upgrade module (Figure 2-12 on page 2-16). Ensure
the cable does not interfere with other connectors.
Upgrading a 20-Slot Library to 40 or 60 Slots
Connecting the Library Modules
2-15