Electrical Safety; Power Cord; Emergency Turn Off; Telephone Line Cord - Xerox WorkCentre WC7530 User Manual

Electrical Safety

Power Cord


Use the power cord supplied with your printer.

Plug the power cord directly into a properly grounded electrical outlet. Make sure that each end of
the cord is securely connected. If you do not know if an outlet is grounded, ask an electrician to check
the outlet.

Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have a
ground connection terminal.
WARNING: Avoid the potential of electrical shock by ensuring that the printer is properly grounded.
Electrical products can be hazardous if misused.

Do not use an extension cord or power strip.

Verify that the printer is plugged into an outlet that is providing the correct voltage and power.
Review the electrical specification of the printer with an electrician if necessary.

Do not place the printer in an area where people can step on the power cord.

Do not place objects on the power cord.

Emergency Turn Off

If any of the following conditions occur, turn off the printer immediately and disconnect the power cord
from the electrical outlet. Contact an authorized Xerox

The equipment emits unusual odors or makes unusual noises.

The power cable is damaged or frayed.

A wall panel circuit breaker, fuse, or other safety device has been tripped.

Liquid is spilled into the printer.

The printer is exposed to water.

Any part of the printer is damaged.

Telephone Line Cord

CAUTION: To reduce the risk of fire, use only No. 26 American Wire Gauge (AWG) or larger
telecommunication line cord.
®
Service Representative to correct the problem:
WorkCentre 7500 Series Multifunction Printer
Safety
11
User Guide