Inserting And Securing The Shelf To The Cabinet (Shoulder Screw Configuration); Truss Head Screws - Dell EMC Data Domain DD9800 Installation Manual

Table 3. Truss head screws
Truss head screw from kit
Steps
1. For Dell EMC racks, use the orange shelf latch handles to push the shelf completely into the cabinet. Align the two
semi-captive M5 shoulder screws on each side with the mounting holes on the cabinet. Thread the shoulder screws into the
mounting holes and finger-tighten the shoulder screws.
Figure 33. Inserting and securing the shelf to the cabinet (shoulder screw configuration)
● To install the shelf into a third-party rack that is not compatible with the M5 shoulder screws, do the following:
a. Remove the semi-captive M5 screws by sliding them from the ears.
Part number and description
036-032-010
Screw, M5-0.8x12, Truss Head Phillips
with patch
036-032-011
Screw, M6-1.0x12, Truss Head Phillips
with patch
036-032-009
Screw, 10-32x.5, Truss Head Phillips
with patch
036-032-012
Screw, 12-24x.5, Truss Head Phillips
with patch
Suggested use
Can be used in Dell EMC racks and
third-party non-threaded hole racks.
Can be used in non-Dell EMC racks.
Can be used in non-Dell EMC racks.
Can be used in non-Dell EMC racks.
Install the Disk Shelves in the Rack 37