HMS Networks Anybus Wireless Bolt Serial AWB2010 User Manual page 33

Configure Settings in the Built-In Web Interface
5.9.9. Bluetooth Settings General
Figure 15. Bluetooth Settings page
General settings
Setting
Enable
Operating Mode
Local Name
Connectable
Discoverable
Connect to settings
Setting
Security Mode
Paired devices
The currently connected Bluetooth devices DHCP Client-ID are listed in the Paired devices panel.
To unpaire a devices, click Unpaire.
SCM-1202-143 2.0
Description
Enable/disable the Bluetooth interface.
PANU (Client): The unit will operate as a Bluetooth PAN (Personal Area Network) User device. It can connect
to another single Bluetooth PANU device or to a Bluetooth Network Access Point.
NAP (Access Point): The unit will operate as a Bluetooth Network Access Point. It can connect to up to 7
Bluetooth PANU devices.
Identifies the unit to other Bluetooth devices. If left blank, the unit will use a default name including the last 6
characters of the MAC ID.
Enable to make the unit accept connections initiated by other Bluetooth devices.
Enable to make the unit visible to other Bluetooth devices.
Description
Disabled: No encryption or authentication.
PIN: Encrypted connection with PIN code security. This mode only works between two units of this type and
brand (not with third-party devices). PIN codes must consist of 4 to 6 digits.
Just Works: Encrypted connection without PIN code.
® ™
Anybus Wireless Bolt Serial
Page 29 of 60