HMS Networks Anybus Wireless Bolt Serial AWB2010 User Manual page 23

Configuration with AT Commands
5.8.1. Enable Fast Roaming with AT Commands
Fast Roaming is only used for Client Mode.
Fast Roaming is enabled as default but can be permanently disabled using AT commands.
Procedure
Enable or Disable Fast Roaming.
1. To Enable or Disable Fast Roaming, change the value of register 4004.
• Enable Fast Roaming:
ATS4004=1
• Disable Fast Roaming:
ATS4004=0
2. For the command to take effect, reboot the Bolt Serial.
Send the Reboot device AT Command:
AT*AMREBOOT
For more information about how to set up WLAN roaming, see the AT Commands Reference Guide or the Help
page in the built-in web interface.
5.8.2. Digital Input
The digital input can be used to control roaming between Bluetooth access points (NAP).
For more information, refer to the AT Commands Reference Guide at www.anybus.com/support.
IMPORTANT
If voltage is applied to the digital input for more that 10 seconds the unit will be reset to factory
defaults.
SCM-1202-143 2.0
® ™
Anybus Wireless Bolt Serial
Page 19 of 60