HMS Networks Anybus Wireless Bolt Serial AWB2010 User Manual page 19

Configuration Methods
5.5. Configuration Methods
There are different methods available for configuring the Bolt Serial.
Built-In Web Interface Settings
Bolt Serial can be configured via the settings in the built-in web interface.
See Configure Settings in the Built-In Web Interface (page
Easy Config Modes
Bolt Serial can be configured using one of the pre-configured Easy Config modes.
See Configuration with Easy Config (page
AT Commands
Advanced configuration can be carried out by issuing AT (modem) commands through the web interface or over
a Telnet or RAW TCP connection to port 8080.
For more information about how to use the AT commands, navigate to the built-in web interface Help page or
see the AT Commands Reference Guide.
See also Configuration with AT Commands (page
5.6. Wireless Configuration via Access Point Unit
Configuration of Wireless Bolt and Bridge Clients can be performed wirelessly, via a PC connected to the Wireless
Bolt or Bridge Access Point.
When connection is established via the wireless interface, the Wireless Bolt or Bridge Client does not need to be
connected with an Ethernet cable during configuration.
SCM-1202-143 2.0
22).
16).
18).
® ™
Anybus Wireless Bolt Serial
Page 15 of 60