Danfoss iC7 Installation Manual page 14

Installation Guide | iC7-Automation Air-cooled Enclosed Drives
1 PE busbar
3 Cable shield
5 Grommet
7
Cable tie
B IP54
8.
Connect the mains cables to the terminals L1, L2, and L3, and the motor cables to the terminals U, V, and W.
See the correct tightening torques in
9. Connect the grounding conductors to the PE busbar.
Figure 13: Cabling of the Enclosed Drive
1
Motor cables
3 Grounding conductor
10.
Release and lower the service table.
3.3.2 Installing the Power Cables through the Top (+KCIT or +KDOT)
Use these instructions with the options Top-entry +KCIT and +KDOT.
14 | Danfoss Drives Oy © 2024.09
2
4
6
A
C
6.1 Tightening Torques.
1
2
3
4
2
4
Grommet holder
Cable clamp
Knitted metal mesh tube
IP21
EMC 360° (IP54 and knitted metal mesh tube)
Mains cables
PE busbar
AN484843731544en-000101 / 172K4825A
Electrical Installation