Hard Disk Drive; Removing The Drive Bay Cover - NEC VERSA 6220 Service Manual

Hard Disk Drive

To disassemble the entire NEC Versa computer, start by removing the hard disk drive as
follows.
Check that the NEC Versa power is off.
1.
2. Turn the NEC Versa upside down with the front of the unit facing you.
3. Remove the drive cover as follows:
T
Locate the drive cover screw. Remove screw. Push the drive cover release
latch up while using some pressure to slide the cover to the left.
T
Lift the cover up and off the system.
NOTE
NEC Versa hard disk drives can be used in
other NEC notebook computers such as the NEC
Versa 2000 and 4000 Series systems. However,
hard disk drives from earlier models can only be
used in the VersaBay II. Check the top of the
hard drive for a blue dot. If the drive case has the
blue dot on it, you can use the drive in either the
drive bay or the VersaBay II.
Figure 4-1 Removing the Drive Bay Cover
Field Service Guidelines 4-5