Dip Switches - NEC VERSA 6220 Service Manual

6. Carefully turn over the keyboard and place it face down on the VersaGlide. Be
careful not to twist or disconnect the keyboard cable.
7. Locate the dip switch block. Using a fine tipped object, change the Dip Switch 1
setting to Off. (For other functions, set the appropriate switch to the required set-
ting. See "Setting Switches" for switch functions and settings.)
Never use a lead pencil, ball point pen or ink pen
to change switch settings.
NOTE
The system memory expansion slots are
also located underneath the keyboard. Therefore,
if you need to install DIMM modules, you might
want to do so while the system is already
disassembled.
Reassemble the system as follows:
8.
T
Lift up the keyboard and align the tabs on the front of it with the grooves in
the system.
T
Reseat the keyboard in its original position.
!
CAUTION
Figure 2-17 Dip Switches
Setup and Operation 2-19