Setting Switches; Dip Switch Location - NEC VERSA 6220 Service Manual

2. Press the Power button to turn off the system.

Setting Switches

A six-position dip switch is located underneath the keyboard. (Dip switch instructions and
location for accessing the switches follows this section.) The following lists identifies each
switch setting and its function.
T
Switch 1, BIOS Flash Protection Switch — The default setting is "ON." Change
the setting to "OFF" when you update your system's basic input/output system
(or BIOS) flash memory. See "Updating the System BIOS," to complete this
procedure.
T
Switch 2, Password Override Switch — The default setting is "OFF." For exam-
ple, if you forget your password and cannot access the data on your NEC Versa,
change the setting to "ON" and your current password dissolves.
To enter a new password, reset the switch to "OFF," and follow the instructions
in Chapter 3, "Using Setup," to set up a new password. You may want to keep
this password in a special place so that you don't forget it again!
Figure 2-12 Dip Switch Location
NOTE
Switches 3, 4, and 6 are reserved for NEC
factory use only. Switch 5 is not used.
Setup and Operation 2-15