Lcd Status Bar And Power Button - NEC VERSA 6220 Service Manual

LCD Status Bar and Power Button

Remove the LCD status bar and Power button as follows.
1. Remove the keyboard, LCD and top cover as previously described.
When the LCD and top cover are removed the Power button sets unattached on
2.
the Graph board over the Power switch.
Remove the LCD status bar as follows.
3.
T
Locate the ribbon cable that attaches to the Graph board via connector P9.
T
Use the tip of a screwdriver and carefully open the connector tabs.
T
Lift up the LCD status bar.
Figure 4-18 LCD Status Bar
Field Service Guidelines 4-19