Performing The Bios Update; Reassembling The System - NEC VERSA 6220 Service Manual

2-20 Setup and Operation
T
Slide the speaker caps back onto the system.
T
Close the LCD panel and turn the system upside down.
T
Replace the speaker cap screws.
9. Your system is now ready for the BIOS update. Continue to the next section to
update the BIOS.

Performing the BIOS Update

Use the following procedure to perform the actual BIOS update.
1. Make sure that the computer is operating under AC power, and that the power is
off. Insert the BIOS Update diskette into diskette drive A.
2. Power on the computer with the diskette in drive A. The computer boots and
automatically loads the utility. A message similar to the following appears:
WARNING: The BIOS Update Procedure
is about to begin, press ENTER to continue.
To abort, remove the diskette and reset the unit.
Press
3. Enter
The utility checks the currently installed BIOS version and the diskette's BIOS
version. The Main Menu appears.
Figure 2-18 Reassembling the System
to continue.