NEC POWERMATE VT 300 Manual page 55

Advanced Menu - Power Management Setup
Menu Item
Restore on AC/Power Loss
Ring Resume from Soft Off
LAN Resume from Soft Off
RTC Alarm Resume from Soft
Off
RTC Alarm Date
RTC Alarm Hour
RTC Alarm Minute
RTC Alarm Second
Settings (default is bold)
Stay Off, Power On, Last State
The Power On setting turns power on after a
power loss. Jumper JP1 must be set for
Power On (see "Setting System Board
Jumpers" for procedures on setting JP1).
Disabled, Enabled
The Disabled setting causes the system to
ignore any incoming call from a modem.
Enabled allows the system to boot up on an
incoming telephone call. Not supported on
Windows 98 systems.
Disabled, Enabled
The Disabled setting causes the system to
ignore any incoming signal from the LAN
network board. Enabled allows the system to
boot up on an incoming LAN signal from the
network board.
Disabled, Enabled
When Enabled, you can choose the time the
system boots up (see the following time
settings).
Sets the day that the system boots up (when
RTC Alarm Resume is Enabled).
Sets real time clock alarm hour (when RTC
Alarm Resume is Enabled).
Sets real time clock alarm minute (when RTC
Alarm Resume is Enabled).
Sets real time clock alarm second (when RTC
Alarm Resume is Enabled).
Configuring the System 3-15