Removing The Pentium Ii Processor - NEC POWERMATE VT 300 Manual

8. Install the left side panel (see "Replacing the Left Side
Panel" earlier in this chapter).
9. Connect any peripherals and power cords, and power up
the system.

Removing the Pentium II Processor

Remove the Pentium II processor cartridge from its Slot 1
socket and universal retention mechanism on the system
board as follows.
Before handling components, reduce static
discharge by touching the chassis.
1. Remove the left side cover (see "Removing the Left Side
Cover" earlier in this chapter).
2. Position the system on its right side for easier access to
the system board and processor cartridge.
If the system was just running, the processor
cartridge and heat sink on the system board are
hot. To avoid a burn, let the components cool for
about 10 minutes before continuing.
3. Locate the processor on the system board (see the figure
"System board sockets and connectors" earlier in this
chapter).
4-24 Installing Options
! CAUTION
!
WARNING