Installing The Agp Graphics Board - NEC POWERMATE VT 300 Manual

2. Remove the screw holding the AGP board in its
expansion slot (see the figure "Locating expansion board
slots and connectors" for the location of the board and
screw).
3. Carefully pull the AGP board out of its connector on the
system board.
4. Set the AGP board on an antistatic surface or in an
antistatic bag.
5. Install an AGP board (see "Installing the AGP Graphics
Board" in the next section).

Installing the AGP Graphics Board

Install an AGP graphics board as follows.
1. Remove the current AGP graphics board (see "Removing
the AGP Graphics Board" earlier in this section).
2. Insert the new AGP board in the AGP connector on the
system board.
3. Secure the board to the chassis with the previously
removed screw.
4. Replace the left side cover (see "Replacing the Left Side
Cover" earlier in this chapter).
4-34 Installing Options