System Board Options - NEC POWERMATE VT 300 Manual

4. Firmly press the cover against the chassis and slide the
cover towards the front of the chassis until it locks in
place.
:
Note
the way to the front of the chassis, check that the
cover tabs at the left side of the cover are
properly inserted into their slots in the chassis.
5. Replace the three previously removed screws.
6. Replace the left side cover (see "Replacing the Left Side
Cover" earlier in this chapter).
7. Reconnect all external peripherals.
8. Plug in your power cables.

System Board Options

This section describes how to upgrade options on the system
board. Procedures described in this section include:
T
adding memory modules
T
upgrading the processor.
The following figure shows the locations of the sockets and
connectors on the system board.
4-12 Installing Options
If the right side cover does not slide all