Ide Drive Cabling - NEC POWERMATE VT 300 Manual

IDE Drive Cabling

Use the following procedure to cable an IDE drive.
:
Note
vary from the one shown.
1. Connect the signal cable connector to the connector on
the IDE drive. Use care to prevent bending connector
pins. Align the cable connector as shown in the following
figure).
2. Locate an available power connector coming from the
power supply.
3. Connect the appropriate power cable to the power
connector on the IDE drive.
Connecting the IDE drive cable
A – Connects to System Board IDE Connector
4-42 Installing Options
The appearance of your device may
B – Connects to IDE Devices