1/4-Inch Device Placement - NEC IMAGE P100E Service Manual

5 1/4-Inch Device Placement

Install the storage device into the 5 1/4-inch device slot as follows.
Remove the top cover, front panel assembly, and 5 1/4-inch device cage as
1.
previously described.
2. Slide the rear of the device into the 5 1/4-inch slot. (Be sure that the load/release
button on the diskette drive is on the right if sliding a diskette drive into the
device cage.)
Align the holes on the 5 1/4-inch device with the holes in the device cage.
3. Install the four device screws that were removed with the rails or that come with
the kit, two on each side of the device cage (see Figure Section 3-26).
Screws
Screws
NOTE: When installing a 3 1/2-inch hard disk
drive into a 5 1/4-inch accessible device slot, a
5 1/4-inch hard disk bracket must first be
attached to the 3 1/2-inch hard disk drive.
When installing any accessible storage device,
install the device in the lowest empty bay. If you
do not, you cannot reinstall the blank slot cover
plates over any remaining empty bays.
Figure Section 3-26 5 1/4-Inch Device Screws
Options 3-33
Screws
Screws