NEC IMAGE P100E Service Manual page 178

4-28 Troubleshooting and Repair
Remove the SIMM modules from the memory expansion board as follows.
1. Spread apart the two clips at each end of the SIMM stick (the clips are part of the
memory expansion board's connectors). The SIMM stick tilts forward, allowing
the post to slide out of the hole in the SIMM stick (see Figure Section 4-12).
2. Remove the SIMM stick from the system board. Repeat step 1 and 2 for each
SIMM to be removed.
Figure Section 4-12 SIMM Removal
NOTE: Depending on which SIMM you are
removing, you may have to release one or more
SIMMs in front of the SIMM being removed.
If more detailed information is needed on SIMM
removal, installation, and memory configuration,
see the installation instructions in Section 3,
Options.
Clips