SYSTEM BOARD SWITCH AND JUMPER SETTINGS
Figure Section 2-5 shows the factory settings and locations of the system board switches
and jumpers. Switch and jumper setting explanations follow the figure.
Figure Section 2-5 System Board Switches and Jumpers
Switch Settings
Table Section 2-21 shows the factory settings of the system configuration switch (SW4)
and explains the function of each position.
Setup and Operation
J39 (VRE
Enable/Disable)
J34 (Pipeline
Enable/disable)
J33 (Primary Cache
Write-Back/Write-
Through)
O
1
System Configuration
F
Switch SW4
4
F
2-57