Scsi Disk Utilities - NEC IMAGE P100E Service Manual

2-54 Setup and Operation
Table Section 2-20 Advanced Configuration Options
Parameters
Reset SCSI Bus at
IC Initialization
Note: The following options have no effect if the BIOS is disabled.
Host Adapter BIOS
Support Removal
Disks under BIOS
at Fixed Disks
Extended BIOS
Translations for Drives
Greater than 1 GByte
BIOS Support For
More Than 2 Drives
(MS-DOS 5.0 and
above)

SCSI Disk Utilities

Use the SCSI Disk Utilities option to check what SCSI devices are currently installed in
your system and to set the SCSI ID number on any optional SCSI devices that you may in-
stall.
At the SCSI Select utility opening screen, position the cursor to SCSI Disk Utilities and
press to display the SCSI Disk Utilities menu.
Enter
Before opening the menu, the utility scans your system for installed SCSI devices as indi-
cated by a Scanning message on your screen.
On completion of the scan, a screen similar to the following displays.
Options
Enable (default)
Disable
Enable (default)
Disable
Boot Only (default)
All Disks Enabled
Enable (default)
Disable
Enable (defualt)
Disable
NOTE: The screen shown is typical of your
system. The actual items on the menu depend
upon the hardware installed in your system.
Description
Enables or disables the Reset
SCSI Bus at Initialization.
Enables or disables the host
adapter BIOS
Allows use of removable hard
disks as fixed hard disk under
BIOS control.
Enables or disables extended
BIOS support for 1-GB or larger
drives.
Enables or disables BIOS support
for more than two drives.