Exit; Pci Devices And Plug And Play Isa Boards - NEC IMAGE P100E Service Manual

Use the following steps to copy or update configuration files.
1. Select "Maintain System Configuration Diskette" from the Main Menu.
Remove the ECU diskette from the diskette drive and replace it with the configu-
2.
ration diskette that came with the option board.
3. Select "Copy/update CFG files" from the menu.
4. Press . A screen appears showing the availableconfiguration files available.
Enter
Select the configuration file you need to copy. You can only copy one file at a
5.
time. Press
You are prompted to remove the configuration diskette.
Remove the diskette and replace it with the ECU diskette.
6.
After replacing the diskette, the CFG file is copied onto the ECU diskette.
Repeat Steps 5 and 6 to copy all the configuration files you need onto the ECU
7.
diskette.

Exit

Select this option to exit the EISA Configuration Utility.
If you are setting up the system for the first time and you have a SCSI device (such as a
SCSI hard disk), see "SCSI Setup Utility" later in this section.

PCI Devices and Plug and Play ISA Boards

Whenever you install a PCI device or Plug and Play ISA board in the system, run the ECU
and select "Configure Computer or Peripheral Devices."
This configuration procedure automatically loads configuration information and adds the
PCI device or Plug and Play board to the configuration. Select "Step 3: View or Edit De-
tails" to check system parameters and "Step 4: Examine Required Switches" to print out
system configuration information.
Be sure to select Step 5 in the Configure Computer or Peripheral Devices menu and save
your configuration.
.
Enter
Setup and Operation 2-45