Save Changes - NEC IMAGE P100E Service Manual

2-28 Setup and Operation
Pressing Enter at "Continue" exits Setup and reboots your system.
If, during bootup, the BIOS program detects a problem in the integrity of values stored in
CMOS, it displays these messages:
The CMOS values have been corrupted or modified incorrectly, perhaps by an application
program that changes data stored in CMOS.
Press F1 to resume the boot or
into the menus. Other changes can be made before saving the values to CMOS.
Load Previous Values
During a Setup session, if a mistake has been made and has not yet been saved to CMOS,
the previously saved CMOS values can be restored.
Selecting Load Previous Values on the Exit menu updates all the selections and displays
this message:

Save Changes

Save Changes saves all the selections without exiting Setup. Other menu selections can be
reviewed or changed.
Selecting Save Changes on the Exit menu saves your changes and displays the following
message:
Pressing at "Continue" exits Setup and reboots your system.
Enter
Default values have been loaded.
[continue]
System CMOS checksum bad - run SETUP
Press <F1> to resume, <F2> to Setup
F2 to run Setup with the ROM default values already loaded
Previous values have been loaded!
[continue]
Changes have been saved
[continue]