Error Messages; Asset Management Identification - NEC IMAGE P100E Service Manual

To hang up and log off, follow these steps at the NEC Technologies Bulletin Board:
Press
1.
Enter
Press (command for Goodbye/Hangup).
2.
G
3. Press .
Enter

Error Messages

Table Section 4-2 describes the possible error and warning messages that may be displayed
when using the BIOS Update Utility.
Table Section 4-2 BIOS Update Utility Error Messages
Message
An error indicates that the
system does not contain a
Flash ROM.
Contact technical support for
update information.
Contact technical support for
update information.
A message indicates that the
update is in progress.
An error notes that the system
does not have enough RAM
available.
A message states that the
diskette you are about to use
has already been used.
An error indicates that you are
attempting to restore the
original BIOS before installing
the new BIOS.

ASSET MANAGEMENT IDENTIFICATION

The asset management program can only be obtained by downloading the
ASSETMGT.EXE file from the NEC BBS. Instructions for logging onto the BBS were
provided earlier in this section.
(to continue).
Action
The utility cannot be used.
A message states that the system's version of BIOS cannot be
updated by diskette because it's not a supported version.
An error indicates that the system BIOS reprogramming is not
enabled or possibly that no Flash ROM is installed. The utility
cannot be used.
Do not disturb the system in any way while this screen appears.
The system resets after the update completes.
Make sure you boot the system from the BIOS Update Utility
diskette.
The previously installed BIOS may not be restored if the update
is continued. This condition is acceptable if a separate copy of
the utility diskette is kept for each system.
First install the new BIOS.
Troubleshooting and Repair 4-5