Ip Address - SMC Networks 6724AL2 Management Manual

C L
OMMAND INE
Command

ip address

ip dhcp restart Submits a BOOTP or DCHP client request
ip
default-gateway
show ip
interface
show ip
redirects
ping
ip address
Use this command to set the IP address for the currently selected VLAN
interface. Use the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
Default Setting
DHCP is enabled by default.
Command Mode
Interface Configuration (VLAN)
3-68
I
NTERFACE
Function
Sets the IP address for the current interface
Defines the default gateway through which an
in-band management station can reach this
device
Displays the IP settings for this device
Displays the default gateway configured for this
device
Sends ICMP echo request packets to another
node on the network
Mode Page
IC 3-69
PE 3-70
GC 3-71
PE 3-72
PE 3-73
NE, 3-73
PE