Ip Ssh Server - SMC Networks 6724AL2 Management Manual

station clients, and ensures that data traveling over the network arrives
unaltered.
This section describes the commands used to configure the SSH server.
However, note that you also need to install a SSH client on the
management station when using this protocol to configure the switch.
Note:The switch supports only SSH Version 1.5.
Command

ip ssh server

ip ssh
show ip ssh
disconnect ssh Terminates an SSH connection
show ssh
ip ssh server
Use this command to enable the Secure Shell (SSH) server on this switch.
Use the no form to disable this service.
Syntax
[no] ip ssh server
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• The SSH server supports up to four client sessions. The maximum
number of client sessions includes both current Telnet sessions and
SSH sessions.
Function
Enables the SSH server on the switch
Specifies the authentication timeout for the SSH
server and the number of retries allowed by a
client
Displays the status of the SSH server and the
configured values for authentication timeout and
retries
Displays the status of current SSH sessions
S S
ECURE HELL
Mode Page
GC
GC
PE
PE
PE
C
OMMANDS
3-49
3-50
3-51
3-51
3-52
3-49