AddSecure NGP Advanced Installation Manual page 31

Web passcode
This code is used to set up both the installer and customer app,
it can be changed from its default.
Configuration
1
Network
3
Web Passcode
5
12345678
Use enter, up and down to change
Web Passcode*
7
8765432 1
This passcode can be changed any time, if required, via this menu within settings.
For best practice, mobile app access requires the Installer to set up a Web passcode
and pin in the device and then advise and show the end customer how to change the PIN.
Edit mode for that part of the menu can be exited at any time, without saving changes,
by pressing for 5s. This will return you to the sub-menu that you were making
changes in.
The configuration menu can be exited at any time without saving any changes by
pressing for 5s. This will take you back to the scrolling status display.
www.addsecure.com
Inputs
Press until shows
ETH DHCP
Enabled
Press until shows
Web Passcode*
1 2345678
Notice –
Saved!
Press and hold
MAIN MENU DISPLAY
Serial connection panel type
This menu selects the panel connection type for serial
connected panels (RS232 or RS485).
Settings:
2
y None
y Menvier
y Dimension GD 232 (Galaxy
Dimension 48/96/264/520
4
(RS232 9600 8n1))
y Dimension GD 485 (Galaxy
Dimension 48/96/264/520
(RS485))
6 y Galaxy G3 232 (G3
48/144/520 (RS232 9600
8n1))
y
Galaxy G3 485 (G3
48/144/520 (RS485))
8
y
Galaxy G2 485 (G212/20/44
(RS485))
y
Galaxy Classic 485 L
(Classic 8/18/60/128
(RS485))
y
Galaxy Flex 485
y
Galaxy Classic 485 H
(Classic 500/504/512
(RS485))
31
y Texecom 816 (Texecom
412/816/832 (RS232 19200
8n2 inv))
y
Texecom 48 88 (Texecom
48/88/168 Com – IP(RS232
19200 8n2 inv))
y
Texecom Premier
(Texecom Premier Elite 48
Com-IP (RS232 19200 8n2
inv))
y Bespoke Panel
y Pyronix (RS232 9600 8n1)
(Europe only not UK)
y Contact IP (RS232
9600/2400/1200 8n1)
y Panel RS232 UDL (8n1)
y
Contact IPv2
y
Eaton I-ON
NGP Advanced and NGP Advanced Extra