AddSecure NGP Advanced Installation Manual page 30

Tunnel port
You can select an alternative tunnel port by accessing the Tunnel Port menu
under Network:
y 443 (default)
y
10443
Example – changing the unit to use Port 10443
Configuration
1
Network
3
Tunnel Port
5
443
Tunnel Port*
7
10443
www.addsecure.com
Inputs
Press until shows
DSL/FTTP
Mode
DHCP
Press until shows
Tunnel Port*
443
Notice –
Saved!
Press and hold
MAIN MENU DISPLAY
When used in IP mode, the unit will attempt to establish a
connection to the AddSecure servers by signalling on IP Port
443. For most LANs this will function correctly, but on some
NGP Advanced LAN configurations the network manager
may not allow outgoing access on port 443 but 10443 may
have outgoing access. Where this is the case then the unit
can be configured to use the alternative port 10443. The
AddSecure servers are set to accept both ports and so no
changes are required other than on the unit's configuration.
y Access the configuration menu by holding the Enter
button for 3s. Press the Enter button again, the display will
2
show 'Pin Learn'. Press the down arrow until 'Network' is
displayed. Press the Enter button again. The display will
show 'DSL/FTTP Mode'. Use the down arrow to step through
until 'Tunnel Port 443' is displayed. Press the Enter button. *
will be displayed. Use down arrow to change to 10443.
4
y Once selected hold the Enter button down till 'Notice –
Saved!' is displayed.
DNS Addr 1
Required to convert host names that are used to contact the
6
server.
DNS Addr 1
Alternative DNS addresses e.g. 8.8.8.8 or 1.1.1.1.
Edit mode for that part of the menu can be exited at any
time, without saving changes, by pressing
8
return you to the sub-menu that you were making changes in.
The configuration menu can be exited at any time without
saving any changes by pressing
back to the scrolling status display.
30
for 5s. This will
for 5s. This will take you
NGP Advanced and NGP Advanced Extra