AddSecure NGP Advanced Installation Manual page 11

Outputs
Three relay outputs are provided on
screw terminals at the top of the unit.
Output 1 is COMMS, Output 2 is
FUNC, and Output 3 is FIRE.
For fire alarm installations the
indication of 'acknowledgement of
fire alarm' and 'SPT fault' messages
must be provided by the fire panel into
which the SPT is mounted. System fault
indications which are notified by the
line fault output (Output 1) must be
latched by the fire panel as required by
EN 54-21.
See the further sections on outputs
for a full explanation.
www.addsecure.com
MOUNTING AND WIRING
Serial data connections
The serial data connection labelled TX,
RX, B and A is configurable for RS485 or
RS232 connection, depending on the
panel.
This is done in the configuration
menu. These ports allow serial alarm
panel connection.
See the Panel Upload-Download
section.
Dial capture
The Dial Capture (Dial Cap) terminals
enable interfacing with an alarm
panel's digital communicator. The
alarm panel can then send SIA, CID or
Fast Format messages through the unit
to the Alarm Receiving Centre.
Dial Capture can also be used for
upload download UDL allowing remote
access with some types of alarm panel.
11
Ethernet connection
The Ethernet port needs to be
connected to a suitable Ethernet
network using CAT5 cable. For most IP
installations, a standard Ethernet patch
cable can be used. The unit monitors
the valid presence of a 10/100 Mbit
Ethernet link.
Aerial connection
Connect the supplied aerial to the
MMCX connector on the top right of
the unit. Place the aerial in a vertical
position that receives the best
wi-fi coverage. Carry out a survey to
establish the best location.
Connect the supplied aerial to the
MMCX connector on the top right of the
unit. The aerial should be placed in a
vertical position that receives the best
wireless coverage. Carry out a survey to
establish the best location. If necessary,
a selection of high gain and extension
aerials can be purchased via your ARC.
NGP Advanced and NGP Advanced Extra