ZyXEL Communications ZYWALL USG 1000 Support Notes page 52

Encapsulation: Tunnel
Active Protocol: ESP
Encryption: DES
Authentication: SHA1
Perfect Forward Secrecy (PFS): None
Below is a step by step configuration:
1) Login ZyWALL USG GUI and go to Configuration > Objects > Address to create an
address object (local subnet) for remote access.
2) Create another address object for the remote host. The IP Address of the host should be
0.0.0.0, which means that remote user dials in dynamically.
3) Go to Configuration > Network > IPSec VPN > VPN Gateway to create gateway for
remote a VPN client. Because this kind of VPN is initialed from remote user, the Secure
Gateway should be set as dynamic, 0.0.0.0. Also, the VPN peers should keep consistence with
each other for other parameters, such as Pre-Shared Key, ID Type, Encryption and
Authentication proposal and so on.
All contents copyright (c) 2007 ZyXEL Communications Corporation.
Phase2
ZyWALL USG 1000 Support Notes
Phase2
Encapsulation: Tunnel
Active Protocol: ESP
Encryption: DES
Authentication: SHA1
Perfect Forward Secrecy (PFS): None
52