ZyXEL Communications ZYWALL USG 1000 Support Notes page 245

ZyWALL USG 1000 Support Notes
3.1.2 NAT & Virtual Server
Here is an example:
There is a web server located in the DMZ zone. The virtual Server setting in ZyWALL USG is
required here for people outside of WAN to access the Web pages located on the Web Server
in the DMZ zone.
To make this scenario work; follow the configuration steps stated below:
1) Login ZyWALL USG GUI and setup the ge2 interface for internet connection and manually
assign a static IP. Login ZyWALL USG GUI and go to Configuration > Network > Interface
> Edit > ge2
2) Switch to Configuration > Policy > Virtual Server and add a new Virtual Server. Fill in
the mapping information. In our example here, since ge2 is our WAN port, we are going to
245
All contents copyright (c) 2007 ZyXEL Communications Corporation.