ZyXEL Communications ZYWALL USG 1000 Support Notes page 15

ZyWALL USG uses the static IP address for VPN connection. The topology is shown on the
following figure.
User needs to configure the static IP address and then apply to the VPN Gateway
configuration page. The configuration steps are stated below:
6) Login ZyWALL USG 1000 GUI, setup the ge2 interface for internet connection and
manually assign a static IP. The configuration path in ZyWALL USG 1000 and ZyWALL
USG 300 menu are Network > Interface > Ethernet >Edit > ge2
7) Switch to VPN > IPSec VPN > VPN Gateway select interface ge2 as My Address and
then in Security Gateway Address field set the remote gateway IP to 167.35.4.3. The
Local ID Type and content are IP and 210.110.7.1, Peer ID Type and content are IP and
167.35.4.3.
8) Repeat the step1 & 2 to configure the Remote ZyWALL USG 300. The Local ID Type &
content and Peer ID Type & content are reverse to the Local ZyWALL USG 1000.
All contents copyright (c) 2007 ZyXEL Communications Corporation.
ZyWALL USG 1000 Support Notes
1
15