Bridge Mode Procedure; Figure 28 Prompt Before Change To Router Mode - ZyXEL Communications P-2302R-P1 Series User Manual

P-2302R-P1 Series User's Guide

4.2 Bridge Mode Procedure

Follow these steps to change the ZyXEL Device into Bridge mode.
1 Log in to the web configurator. (See
2 Click Maintenance > System > General.
3 In the Mode field, select Bridge.
4 In the Management IP Address field, enter the IP address you want to use to access the
ZyXEL Device in Bridge mode. For example, enter 192.168.5.1.
5 Click Apply.
The ZyXEL Device automatically restarts. When the POWER LED stops blinking and stays
on, follow the directions in
the Management IP Address you set up in step 4. If your computer's IP address is in a
different subnet, follow the directions in
IP address.
When you log in to the web configurator, you can still see every screen in
even if the feature is not available in Bridge mode (in
configure a feature that is not available in Bridge mode, your changes have no effect until you
change back to Router mode.
If you want to change back to Router mode, follow these steps.
1 Log in to the web configurator. (See
2 Click Maintenance > System > General.
3 In the Mode field, select Router.
4 Click Apply.
5 The ZyXEL Device asks you if you want to enable the firewall and NAT. Select OK or
Cancel.

Figure 28 Prompt Before Change to Router Mode

The ZyXEL Device automatically restarts. Use the IP address in Network > LAN > IP to log
in to the web configurator again. You might have to change your computer's IP address again.
70
Chapter 2 on page
Chapter 2 on page 39 to log in to the web configurator again. Use
Appendix B on page 235
Chapter 2 on page
39.)
to change your computer's
Table 3 on page
Table 22 on page 69). However, if you
39.)
Chapter 4 Bridge Mode
43,